64 KB Flash memory with in-circuit programming capability
2 KB or 3.75 KB internal RAM
Internal 32.768 KHz precision oscillator with DCO/FLL
Support for external crystal oscillators
Up to 17-channel, 12/14-bit Analog-to-Digital Converter (ADC)
12-bit Digital-to-Analog Converter (DAC)
Two on-chip analog comparators (32-pin package contains only one)
Two on-chip, low-power operational amplifiers (32-pin package contains only one)
On-chip temperature sensor
128-bit Advanced Encryption Standard (AES) encryption/decryption hardware accelerator
8-channel event system provides communication between peripherals for autonomous triggering
Four-channel DMA controller
Full-speed Universal Serial Bus (USB 2.0) device supporting eight endpoints with integrated USB PHY
Two full-duplex 9-bit UARTs supporting Local Interconnect Network (LIN), Digital Addressable Lighting Interface (DALI) protocols and DMX (32-pin package contains only one)
Enhanced Serial Peripheral Interface (ESPI) controller
I2C controller which supports Master/Slave modes
Real-Time Clock (RTC) supporting both Counter and Clock modes
Three enhanced 16-bit timers with Capture, Compare, and PWM capability
Two additional basic 16-bit timers with interrupts (shared as UART Baud Rate Generator)
16-bit multi-channel timer which supports four Capture/Compare/PWM modules (not available on 32-pin package)
Watchdog Timer (WDT) with independent oscillator
26 to 67 General-Purpose Input/Output (GPIO) pins, depending upon package
On-Chip Debugger (OCD)
Power-On Reset (POR), Voltage Brown-Out (VBO) and Low-Voltage Detection (LVD)
Wide 1.8 V-3.6 V operating voltage range
32– and 44–pin packages
–40°C to +85°C (extended) operating temperature range
Z8F6481 ZMOTION Library Development Board Block Diagram
;
